#Could not install no file final draft 7 how to The Mac you want to flash needs to be able to boot into EFI (Boot selection page) in order to flash it. We have not tested to further extent if you can solder any SMC on any board to flash it. So far, this method has been successfully applied to flash a SMC from a 820-3437 donor soldered on a 820-00165 and a 820-00165 SMC soldered on a 820-3437.
#FINAL DRAFT 7 WILL NOT INSTALL UPDATE#
SMC update and MacOS update have not been tested. Any further compatibility information is welcome.
Gathering the stuff we need Installing rEFIt on a bootable drive Other tools exist and terminal command can be used to do this as well. We recommend to install it on a separate volume or external disk is explained on the website: REFIt will help you boot an EFI on an external drive to launch the shell, SMCutils and other stuffs. Installation procedure is basically the same as explained above: #Could not install no file final draft 7 install
You just need to add it to a "tools" folder on the USB key. Here is the list of BoardID for almost all Macs. : The BoardID is different from the board number, the A number, the part number. Note the board ID from the SMC firmware you need, it will be used to extract the right SMC firmware files. To find SMC rom files, you need to have a bootable dmg file for OSX. Mojave Installation DMG File is used in this example.